![]() ![]() Enertion does something similar on the raptors. Then get your self a pre-compiled BLDC tool from. ![]() I like to curl mine in such a way that they don’t stress. If you buy a pre-made VESC from Ollinboard / Enertion / any valid / known members. and when you run the leads to the ESC, make sure you have slack so that when you carve there isn’t any tension on the leads. So when you’re done rewinding, or even just replacing your phase leads like i do on occasion with colored ones, make sure you do what you can with the heat shrink to keep those phase leads from moving around inside the can. ![]() once they start rubbing, the enamel will start to rub off and chip, then you have shorts. What does end up happening though is the heat shrink at the end of the windings that is near the hole in the motor can ends up coming loose, and if your phase leads are moving around too much because they aren’t bunched correctly to allow movement, the part of the lead that is in the can which becomes the windings (the part clearly shown in the image above) will start to rub together. is right about the windings being enamel coated, they can touch inside the can like that, they’re designed to do that. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |